IDES Prospector Already have an account? Login Here

IDES

Badaflex® TPE-S 75A 1205 2K S2

Styrene Ethylene Butylene Styrene Block Copolymer

Supplied by Bada AG

The technical datasheet with complete property values for Badaflex® TPE-S 75A 1205 2K S2 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Good Adhesion
  • Good Flow
 
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
DIN 53479
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (Yield)
psi
DIN 53504
Tensile Elongation (Break)
%
DIN 53504
Compression Set (73°F, 72.0 hr)
%
DIN 53515
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A)
 
DIN 53505
Additional Information
Nominal Value
Unit
Test Method
Tear Strength
lbf/in
DIN 53515
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Badaflex® TPE-S 75A 1205 2K S2, Badaflex TPES 75A 1205 2K S2, Badaflex® , Badaflex, BadaflexTPES75A12052KS2, TPE, TPE S 75 A 1205 2 K S 2, TPE-S 75A 1205 2K S2, TPES 75A 1205 2K S2, TPE:S 75A 1205 2K S2, TPE/S 75A 1205 2K S2, TPE+S 75A 1205 2K S2, TPE_S 75A 1205 2K S2, TPE S 75A 1205 2K S2, TPES, S75, 75A, A1205, 12052, 2K, KS, S2, TPES75A12052KS2, TPE_S75A12052KS2, Styrene Ethylene Butylene Styrene Block Copolymer, SEBS, Thermoplastic Elastomer, Bada Euro, StyreneEthyleneButyleneStyreneBlockCopolymer, ThermoplasticElastomer, STPE
Features
Features may also be described by the following terms: Good Adhesion, Good Flow.
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Injection Rate
 
 
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.