IDES Prospector Already have an account? Login Here

IDES

Sofprene® 389NKQ1

Styrene Butadiene Rubber

Supplied by SO.F.TER. SPA

The technical datasheet with complete property values for Sofprene® 389NKQ1 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Non-marking compound, does not leave dark signs on the floor.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Low Neck-In
Uses 
  • Footwear
Appearance 
  • Black
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/5.0 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Abrasion Resistance
mm³
 DIN 53516
Elastomers
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D412
Tensile Elongation 2 (Break)
%
 ASTM D412
Tear Strength 2
lbf/in
 ASTM D624
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A, 3 sec)
 
 ASTM D2240
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Sofprene® 389NKQ1, Sofprene 389NKQ1, Sofprene® , Sofprene, Sofprene389NKQ1, 389 NKQ 1, 389NKQ1, 389NKQ, NKQ1, Styrene Butadiene Rubber, Unspecified, Styrene Butadiene Rubber Unspecified, SBR, Unspecified, SBR Unspecified, Polybutadiene Rubber, PBR, Softer SPA, StyreneButadieneRubberUnspecified, SBRUnspecified, PolybutadieneRubber, NKQ389
Features
Features may also be described by the following terms: Low Neck-in, Low Neck In.
Notes
1Typical properties: these are not to be construed as specifications.
2Die C
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.