IDES Prospector Already have an account? Login Here

IDES

Westlake LDPE EC800AA

Low Density Polyethylene

Supplied by Westlake Chemical Corporation

The technical datasheet with complete property values for Westlake LDPE EC800AA is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
WESTLAKE low-density polyethylene EC800 is a general-purpose low-density formulation used for extrusion coating applications.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • North America
  
Uses 
  • Coating Applications
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Coating
  • Extrusion Coating
  
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus - 2% Secant 2
psi
 ASTM D638
Tensile Strength 3 (Break)
psi
 ASTM D638
Tensile Elongation 3 (Break)
%
 ASTM D638
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Westlake LDPE EC800AA, Westlake LDPE , WestlakeLDPEEC800AA, WestlakeLDPE, LDPEEC 800 AA, LDPEEC800AA, LDPEEC800, LDPE, EC 800 AA, EC800AA, EC800, 800AA, Polyethylene, Low Density, Polyethylene Low Density, Polyethylene, PE, Westlake Chem, PolyethyleneLowDensity, 800EC, 800LDPEEC
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
20.50 in/min
320 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.