IDES Prospector Already have an account? Login Here

IDES

Westlake LDPE EC4041AA

Low Density Polyethylene

Supplied by Westlake Chemical Corporation

The technical datasheet with complete property values for Westlake LDPE EC4041AA is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
WESTLAKE low-density polyethylene EC4041 is recommended for use in the boardstock coating industry. The resin has low neck-in and good drawdown characteristics. Coatings produced from EC4041 have excellent heat-sealing characteristics.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • North America
  
Features 
  • Good Drawdown
  • Kosher Approved
  • Low Neck-In
Uses 
  • Non-specific Food Applications
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Coating
  • Extrusion Coating
  
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D4883
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Break, 73°F)
psi
 ASTM D638
Tensile Elongation 2 (Break, 73°F)
%
 ASTM D638
Flexural Modulus - 2% Secant 3 (73°F)
psi
 ASTM D790
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Westlake LDPE EC4041AA, Westlake LDPE , WestlakeLDPEEC4041AA, WestlakeLDPE, LDPEEC 4041 AA, LDPEEC4041AA, LDPEEC4041, LDPE, EC 4041 AA, EC4041AA, EC4041, 4041AA, Polyethylene, Low Density, Polyethylene Low Density, Polyethylene, PE, Westlake Chem, PolyethyleneLowDensity, 4041EC, 4041LDPEEC
Features
Features may also be described by the following terms: Good Drawdown, Good draw down, Low Neck-in, Low Neck In.
Uses
Uses may also be described by the following terms: Food Applications.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2Type IV, 20 in/min
30.50 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.