IDES Prospector Already have an account? Login Here

IDES

HIPEX® HX6IMB

Thermoplastic Elastomer

Supplied by KRAIBURG TPE Corporation

The technical datasheet with complete property values for HIPEX® HX6IMB is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  • North America
Features 
  • High Heat Resistance
  • Oil Resistant
 
Uses 
  • Outdoor Applications
Appearance 
  • Black
Processing Method 
  • Multi Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (Yield)
psi
ISO 37
Tensile Elongation (Break)
%
ISO 37
Tear Strength 2
lbf/in
ISO 34-1
Compression Set
    ISO 815
73°F, 72.0 hr
%
 
212°F, 22.0 hr
%
 
248°F, 22.0 hr
%
 
302°F, 22.0 hr
%
 
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A)
 
ISO 868
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: HIPEX® HX6IMB, HIPEX HX6IMB, HIPEX® , HIPEX, HIPEXHX6IMB, HX 6 IMB, HX6IMB, HX6, 6IMB, Thermoplastic Elastomer, TPE, Kraiburg TPE, ThermoplasticElastomer, 6HX
Features
Features may also be described by the following terms: High Heat Resistance.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
 
Drying Time
hr
 
Suggested Max Moisture
%
 
Rear Temperature
°F
 
Middle Temperature
°F
 
Front Temperature
°F
 
Mold Temperature
°F
 
Injection Pressure
psi
 
Injection Rate
 
 
Back Pressure
psi
 
Notes
1Typical properties: these are not to be construed as specifications.
2Method Bb, Angle (Nicked)
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.