IDES Prospector Already have an account? Login Here

IDES

TAIRIPRO F2011

Polypropylene Homopolymer

Supplied by Formosa Chemicals & Fibre Corporation

The technical datasheet with complete property values for TAIRIPRO F2011 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
FCFC PP resin F2011 meets the requirements of FDA, RoHS and the certificates of environmental protection.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  • North America
Features 
  • Food Contact Acceptable
  • Medium Slip
  
Uses 
  • Film
Agency Ratings 
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield, 73°F)
psi
 ASTM D638
Tensile Elongation (Break, 73°F)
%
 ASTM D638
Flexural Modulus (73°F)
psi
 ASTM D790A
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F, 0.00492 in)
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (R-Scale, 73°F)
 
 ASTM D785
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (66 psi, Unannealed, 0.250 in)
°F
 ASTM D648
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: TAIRIPRO F2011, TAIRIPRO , TAIRIPROF2011, F 2011, F2011, Polypropylene Homopolymer, PP Homopolymer, Polypropylene, PP, Formosa Chemicals, PolypropyleneHomopolymer, PPHomopolymer, 2011F
Features
Features may also be described by the following terms: Medium Slip.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Injection Notes
Screw Temp: 220 to 260 °C
Casting Roll Temp: 30 °C
Cooling water Temp: 30 to 40 °C
Chilling water Temp:12 to 18 °C
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.