IDES Prospector Already have an account? Login Here

IDES

Insulcast R.T.V.S. 13

Silicone

Supplied by American Safety Technologies (Permagile)

The technical datasheet with complete property values for Insulcast R.T.V.S. 13 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • General Purpose
  • Room Temperature Vulcanizing
  
Uses 
  • Molds/Dies/Tools
  • Sealants
  • Tooling
Appearance 
  • Red
Forms 
  • Liquid
Processing Method 
  • Encapsulating
  • Potting
  
Physical
Nominal Value
Unit
Test Method
Apparent Density
g/cm³
 ASTM D1895
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D638
Tensile Elongation (Yield)
%
 ASTM D638
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Max. Continuous Use Temperature
°F
 ASTM D794
CLTE - Flow
in/in/°F
 ASTM D696
Thermal Conductivity
Btu·in/hr/ft²/°F
 ASTM C177
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 ASTM D257
Dielectric Strength
V/mil
 ASTM D149
Dielectric Constant (100 Hz)
 
 ASTM D150
Dissipation Factor (100 Hz)
 
 ASTM D150
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
      
Hardener
 
  
Resin
 
  
Pot Life (72°F)
min
  
Shelf Life (72°F)
wk
  
Thermoset Mix Viscosity
cP
 ASTM D2393
Demold Time (0°F)
min
  
Fill Analysis
Nominal Value
Unit
Test Method
Melt Thermal Conductivity
Btu·in/hr/ft²/°F
 ASTM C177
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Insulcast R.T.V.S. 13, Insulcast RTVS 13, Insulcast R.T.V.S. , Insulcast RTVS, InsulcastRTVS13, InsulcastRTVS, 13, Silicone, Permagile
Features
Features may also be described by the following terms: Room Temperature Vulcanizing, RTV.
Uses
Uses may also be described by the following terms: Sanitary Products, Molds/Dies/Tools, Molds, Dies, tools.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.