ESTALENE EN 10 SSC Cossa Polimeri Polyolefin, Unspecified

Product Description

Estalene EN is a compounds range formulated to be used for the injection or extrusion molding of synthetic corks and it is made without SIS, SBS, SEBS rubbers. Estalene EN is patented by Cossa Polimeri.

The elastic behavior of Estalene EN is obtained with a belnd of modified polyolefins. The product is studied in order to imitate the aspects of natural cork also in its superficial defects.

To have the best performances we suggest the use of Estalene EN matched with an expanding agent (i.e. Estafoam 13 STO) that allows to obtain cells extrememly compact and very well distributed.

The cork made of Estalene EN are equivalent to the traditional ones, concerning weight, functional and aesthetic aspects. The raw material used to produce Estalene EN are suitable for food contact. Estalene EN is certified according to FDA standards.

General

Material Status

Commercial: Active

Availability

Europe

Features

Food Contact Acceptable

High Elasticity

Uses

Synthetic Cork

Agency Ratings

Forms

Pellets

Processing Method

Extrusion

Injection Molding

Physical	Nominal Value	Unit	Test Method
Specific Gravity			ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)		g/10 min	ASTM D1238
Mechanical	Nominal Value	Unit	Test Method
Tensile Strength (Break)		psi	ASTM D638
Tensile Elongation (Break)		%	ASTM D638
Hardness	Nominal Value	Unit	Test Method
Hardness
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ESTALENE EN 10 SSC, ESTALENE EN , ESTALENEEN10SSC, ESTALENEEN, EN 10 SSC, EN10 SSC, EN10, EN, EN10SSC, 10 SSC, 10SSC, Polyolefin, Unspecified, Polyolefin Unspecified, Polyolefin, Cossa Polimeri, PolyolefinUnspecified, SSC10, 10EN
Features
Features may also be described by the following terms: High Elasticity, Highly Elastic.
Uses
Uses may also be described by the following terms: Synthetic Cork.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).

Injection	Nominal Value	Unit
Hopper Temperature		°F
Rear Temperature		°F
Middle Temperature		°F
Front Temperature		°F
Processing (Melt) Temp		°F
Mold Temperature		°F
Injection Rate
Injection Notes
Injection Pressure: according to article dimensions Post Pressure: as low as possible Back Pressure: average to low

Notes

¹Typical properties: these are not to be construed as specifications.

ESTALENE EN 10 SSC

Polyolefin

Supplied by Cossa Polimeri S.r.l.