IDES Prospector Already have an account? Login Here

IDES

Arak HDPE I2

High Density Polyethylene

Supplied by Arak Petrochemical Corporation

The technical datasheet with complete property values for Arak HDPE I2 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
I2 is a high density polyethylene grade, suitable for mass production injection moulding of articles in rapid shot sequence applications.
Characteristics:
  • Easy flowing.
  • Virtually free from distortion.
Typical applications are:
  • Lightweight house-hold less hard and rigid than I1.

* I2 is suitable for food contact.
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
Features 
  • Food Contact Acceptable
  • Good Dimensional Stability
  • Good Flow
Uses 
  • Household Goods
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
DIN 53479
Melt Mass-Flow Rate (MFR) (190°C/5.0 kg)
g/10 min
DIN 53735
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact Strength
ft·lb/in²
DIN 53453
Optical
Nominal Value
Unit
Test Method
Yellowness Index
YI
DIN 6167
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Arak HDPE I2, Arak HDPE , ArakHDPEI2, ArakHDPE, HDPEI 2, HDPEI2, HDPE, I 2, I2, Polyethylene, High Density, Polyethylene High Density, Polyethylene, PE, Arak Petrochemical, PolyethyleneHighDensity, 2I, 2HDPEI
Features
Features may also be described by the following terms: Good Flow, Good Dimensional Stability, Dimensionally Stable.
Uses
Uses may also be described by the following terms: Household Goods, Housewares.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.