IDES Prospector Already have an account? Login Here

IDES

Arak LLDPE LL0209CA

Linear Low Density Polyethylene

Supplied by Arak Petrochemical Corporation

The technical datasheet with complete property values for Arak LLDPE LL0209CA is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
LL0209CA is a linear low density polyethylene copolymer containing butene-1 as a co-monomer.

LL0209CA is suitable for stretch wrap blown films neat or in lean blend with LDPE products.

LL0209CA shows good puncher resistance and cling performance. Typical melt temperature range in extruder is about 180°C - 220°C.

LL0209CA should be stored in the dry condition below the 50°C and avoided from the exposure of direct sunlight.
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
Features 
  • Butene Comonomer
  • Copolymer
  • High Cling
  • Puncture Resistant
  
Uses 
  • Blending
  • Film
  • Stretch Wrap
Processing Method 
  • Film Extrusion
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D2838
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Films
Nominal Value
Unit
Test Method
Film Thickness - Tested
mil
  
Tensile Strength
     ASTM D882
MD: Yield
psi
  
TD: Yield
psi
  
MD: Break
psi
  
TD: Break
psi
  
Tensile Elongation
     ASTM D882
MD: Break
%
  
TD: Break
%
  
Dart Drop Impact
g
 ASTM D1709
Elmendorf Tear Strength
     ASTM D1922
MD: 0.98 mil
g
  
TD: 0.98 mil
g
  
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Optical
Nominal Value
Unit
Test Method
Gloss (45°)
 
 ASTM D2457
Haze
%
 ASTM D1003
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Arak LLDPE LL0209CA, Arak LLDPE , ArakLLDPELL0209CA, ArakLLDPE, LLDPELL 0209 CA, LLDPELL0209CA, LLDPELL0209, LLDPE, LL 0209 CA, LL0209CA, LL0209, 0209CA, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, Polyethylene, PE, Arak Petrochemical, PolyethyleneLinearLowDensity, 0209LL, 0209LLDPELL
Features
Features may also be described by the following terms: Butene Comonomer, High Cling, Good Puncture Resistance, Puncture Resistant.
Uses
Uses may also be described by the following terms: Stretch Wrap.
Extrusion
Nominal Value
Unit
 
Melt Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.