IDES Prospector Already have an account? Login Here

IDES

ORIENTENE MD 12

Polypropylene Homopolymer

Supplied by Oriental Petrochemical Company

The technical datasheet with complete property values for ORIENTENE MD 12 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
Features 
  • Food Contact Acceptable
  • Good Moldability
  • Good Processability
  • Good Processing Stability
  • Good Stretchability
Uses 
  • Tape
Agency Ratings 
 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183, ASTM D1505
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ASTM D1238, ISO 1133
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
      
Yield 2
psi
 ASTM D638
Yield
psi
 ISO 527-2/50
Tensile Elongation
      
Yield 2
%
 ASTM D638
Yield
%
 ISO 527-2/50
Flexural Modulus - 1% Secant 3
psi
 ASTM D790A, ISO 178
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ISO 180, ASTM D256A
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (66 psi, Unannealed)
°F
 ASTM D648, ISO 75-2/B
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ORIENTENE MD 12, ORIENTENE , ORIENTENEMD12, MD 12, MD12, Polypropylene Homopolymer, PP Homopolymer, Polypropylene, PP, Oriental Petrochemical, PolypropyleneHomopolymer, PPHomopolymer, 12MD
Features
Features may also be described by the following terms: Good Processing Stability, Good Process Stability, Good Processability, Easy Processing, Good Moldability, Good Stretchability.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), EU (1).
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
30.051 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.