IDES Prospector Already have an account? Login Here

IDES

LNP* Verton* RV007E

Polyamide 66

Long Glass Fiber

Supplied by SABIC Innovative Plastics Europe

The technical datasheet with complete property values for LNP* Verton* RV007E is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
LNP* Verton* RV007E is a compound based on Nylon 66 resin containing Long Glass Fiber. Added features of this material include: Easy Molding.

Also known as: LNP* Verton* Compound RF-7007 EM
Product reorder name: RV007E
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Filler / Reinforcement 
  • Long Glass Fiber
Features 
  • Good Moldability
RoHS Compliance 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Break)
psi
 ISO 527-2/5
Tensile Strain (Break)
%
 ISO 527-2/5
Flexural Modulus 2
psi
 ISO 178
Flexural Strength 2, 3
psi
 ISO 178
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact Strength 4 (73°F)
ft·lb/in²
 ISO 180/1A
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature 5 (264 psi, Unannealed, 2.52 in Span)
°F
 ISO 75-2/Af
Flammability
Nominal Value
Unit
Test Method
Glow Wire Flammability Index (0.0295 in)
°F
 IEC 60695-2-12
Related Terminology
This supplier and product may also be known by these terms: GE Plastics Europe, LNP Engineering Plastics, GE Polymerland Europe, GE Polymerland, GE Plastics

Product names can be difficult to match. You may have searched any one of these terms to find this product: LNP* Verton* RV007E, LNP Verton RV007E, LNP* Verton* , LNP Verton, LNPVertonRV007E, LNPVerton, RV 007 E, RV007E, RV007, 007E, Polyamide 66, Nylon 66, Polyamide, Nylon, pa66, SABIC IP Euro, Polyamide66, Nylon66, 007RV
Generic Name
Generic Name may also be described by the following terms: PA66.
Features
Features may also be described by the following terms: Good Moldability.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Suggested Max Moisture
%
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Back Pressure
psi
  
Screw Speed
rpm
  
Notes
1Typical properties: these are not to be construed as specifications.
20.079 in/min
3Break
480*10*4
580*10*4 mm
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.