IDES Prospector Already have an account? Login Here

IDES

Haysite Plastics EHC

Thermoset Polyester

Glass Fiber Reinforcement

Supplied by Haysite Reinforced Plastics

The technical datasheet with complete property values for Haysite Plastics EHC is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Filler / Reinforcement 
  • Glass Fiber Reinforcement
Features 
  • Good Creep Resistance
  • High Strength
  
Agency Ratings 
 
Appearance 
  • Brown
Forms 
  • Sheet
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Water Absorption (24 hr)
%
 ASTM D570
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (0.125 in)
psi
 ASTM D638
Flexural Modulus (0.125 in)
psi
 ASTM D790
Flexural Strength (0.125 in)
psi
 ASTM D790
Compressive Strength
psi
 ASTM D695
Shear Strength
psi
 ASTM D732
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (0.125 in)
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Barcol Hardness
 
 ASTM D2583
Electrical
Nominal Value
Unit
Test Method
Dielectric Strength
     ASTM D149
0.0625 in, in Oil 2
V/mil
  
0.125 in 3
V/mil
  
Dielectric Constant
     ASTM D150
60 Hz
 
  
1 MHz
 
  
Dissipation Factor
     ASTM D150
60 Hz
 
  
1 MHz
 
  
Arc Resistance
sec
 ASTM D495
Flammability
Nominal Value
Unit
Test Method
UL File Number
 
  
Additional Information
Flame Resistance, Ignition time, ASTM D229-11: 83 sec
Flame Resistance, Burning time, ASTM D229-11: 221 sec
Temperature class: 155°C
Bond Strength, ASTM D-229, 0.5 in: 2000 psi
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Haysite Plastics EHC, Haysite Plastics , HaysitePlasticsEHC, HaysitePlastics, PlasticsEHC, Plastics, EHC, Polyester, Thermoset, Polyester Thermoset, Polyester, TS, Polyester TS, Thermoset, TS, Haysite, PolyesterThermoset, PolyesterTS
Features
Features may also be described by the following terms: High Strength, Good Creep Resistance, Creep Resistant.
Agency Ratings
This plastic material has 4 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): MIL (1), IEEE (1), FED (1), NEMA (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Method A (Short-Time)
3Method B (Step-by-Step)
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.