Already have an account? Login Here

IDES

Hipolyene 2703 MS EX 3

Thermoplastic Polyolefin Elastomer

Supplied by Zylog Plastalloys

The technical datasheet with complete property values for Hipolyene 2703 MS EX 3 is available to members of the Prospector Plastics Database.
Register to view full datasheet.

General

Material Status

Commercial: Active

Availability

Africa & Middle East

Europe

Uses

Automotive Exterior Parts

Physical	Nominal Value	Unit	Test Method
Specific Gravity			ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)		g/10 min	ASTM D1238
Mechanical	Nominal Value	Unit	Test Method
Tensile Strength (Yield)		psi	ASTM D638
Tensile Elongation (Break)		%	ASTM D638
Flexural Modulus		psi	ASTM D790
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Hipolyene 2703 MS EX 3, Hipolyene , Hipolyene2703MSEX3, 2703 MS EX 3, 2703MS, MSEX, EX3, 2703MSEX3, TPO, Thermoplastic Polyolefin Elastomer, TPO (POE), TPO POE, Thermoplastic Elastomer, TPE, Zylog Plastalloys, ThermoplasticPolyolefinElastomer, TPOPOE, ThermoplasticElastomer, MS2703

Notes

¹Typical properties: these are not to be construed as specifications.

Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.