|
Density
|
|
g/cm³
|
ASTM D1505 |
|
Melt Mass-Flow Rate (MFR)
|
|
|
ASTM D1238 |
|
190°C/2.16 kg
|
|
g/10 min
|
|
|
190°C/21.6 kg
|
|
g/10 min
|
|
|
Environmental Stress-Cracking Resistance
|
|
|
|
|
10% Igepal, F50
|
|
hr
|
ASTM D1693B |
|
100% Igepal, F20
|
|
hr
|
ASTM D1693C |
|
Notched Constant Ligament Stress (NCLS) 2
|
|
hr
|
ASTM F2136 |
|
Tensile Strength 3 (Yield)
|
|
psi
|
ASTM D638 |
|
Tensile Elongation 3 (Break)
|
|
%
|
ASTM D638 |
|
Flexural Modulus - Tangent 4 (16.0 in Span)
|
|
psi
|
ASTM D790 |
|
Oxidation Induction Time (392°F)
|
|
hr
|
ASTM D3895 |
|
The nominal properties reported herein are typical of the product, but do not reflect normal testing variance and therefore shout not be used for specification purposes. Values are rounded. The typical properties were determined on compression molded specimens that were prepared in accordance with Procedure C of ASTM D4703, Annex A1.
|
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: MarFlex® 9377, MarFlex 9377, MarFlex® , MarFlex, MarFlex9377, 9377, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, CP Chem, PolyethyleneLinearLowDensity
|
|
Features may also be described by the following terms: High Gloss, Good Melt Strength, Good Stiffness, High Environmental Stress Cracking Resistance, High ESCR, Stress Cracking Resistant.
|
|
This plastic material has 4 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): ASTM (3), AASHTO (1).
|