IDES Prospector Already have an account? Login Here

IDES

HIPTEN® 22007 A17

Low Density Polyethylene

Supplied by HIP-PetroHemija

The technical datasheet with complete property values for HIPTEN® 22007 A17 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
HIPTEN® 22007A17 is low density polyethylene resin developed for production of shrink film,carrier bags. HIPTEN® 22007A17 has outstanding mechanical properties, very good processability and homogeneous appearance and good heat welding.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  
Features 
  • Food Contact Acceptable
  • Good Processability
  • Recyclable Material
Uses 
  • Bags
  • Film
  • Shrink Wrap
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Blown Film
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ISO 1133
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress
     ISO 527-2
Yield
psi
  
Break
psi
  
Tensile Strain (Break)
%
 ISO 527-2
Films
Nominal Value
Unit
Test Method
Tensile Stress
     ISO 1184
TD: Yield
psi
  
MD
psi
  
TD
psi
  
Tensile Elongation
     ISO 527-3
MD: Break
%
  
TD: Break
%
  
Dart Drop Impact
g
 ASTM D1709
Elmendorf Tear Strength
     ASTM D1922
MD
lbf/in
  
TD
lbf/in
  
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore D)
 
 ISO 868
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ISO 306
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: HIPTEN® 22007 A17, HIPTEN 22007 A17, HIPTEN® , HIPTEN, HIPTEN22007A17, 22007 A 17, 22007 A17, 22007A, A17, 22007A17, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, HIP-PetroHemija, PolyethyleneLowDensity, A22007
Features
Features may also be described by the following terms: Good Processability, Easy Processing.
Uses
Uses may also be described by the following terms: Shrink Wrap.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): EC (1).
Extrusion
Nominal Value
Unit
 
Melt Temperature
°F
  
Extrusion Notes
Blow-up Ratio: 2 to 3:1
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.