IDES Prospector Already have an account? Login Here

IDES

Elastocon® CLR75

Thermoplastic Elastomer

Supplied by Elastocon TPE Technologies

The technical datasheet with complete property values for Elastocon® CLR75 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Elastocon® CLR75 is a transparent thermoplastic elastomer that has been developed for applications that require oil/plasticizer free, non-blooming high strength properties and a tactil
surface finish. Elastocon?? CLR75 is FDA compliant and well suited for consumer goods and industrial applications requiring U.V. stability. Elastocon?? CLR75 can be overmolded onto polypropylene.

Elastocon® CLR75 is supplied as ready to use pellets in 1000 lb. quantities.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
  • North America
  
Features 
  • Good UV Resistance
  • High Strength
  • Non-Blooming
  • Non-Smooth Surface Finish
  
Uses 
  • Consumer Applications
  • Industrial Applications
  • Overmolding
Agency Ratings 
Appearance 
  • Clear/Transparent
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (100% Strain)
psi
 ASTM D412
Tensile Strength (Yield)
psi
 ASTM D412
Tensile Elongation (Break)
%
 ASTM D412
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Elastocon® CLR75, Elastocon CLR75, Elastocon® , Elastocon, ElastoconCLR75, CLR 75, CLR75, Thermoplastic Elastomer, TPE, ThermoplasticElastomer, 75CLR
Features
Features may also be described by the following terms: Non-Blooming, Non Blooming, High Strength, Non-Smooth Surface Finish, Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Rear Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Mold Temperature
°F
  
Injection Rate
 
  
Back Pressure
psi
  
Injection Notes
Elastocon® CLR40 thermoplastic elastomer compound does not require drying.
Extrusion
Nominal Value
Unit
 
Hopper Temperature
°F
  
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Die Temperature
°F
  
Extrusion Notes
Compression ratio: 2.5 to 3.0
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.