IDES Prospector Already have an account? Login Here

IDES

Marlex® H525

High Density Polyethylene

Supplied by Chevron Phillips Chemical Company LLC

The technical datasheet with complete property values for Marlex® H525 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Crack Resistance
Uses 
  • Piping
Agency Ratings 
Processing Method 
  • Pipe Extrusion
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/21.6 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Flexural Modulus - 2% Secant 3
psi
 ASTM D790
Hydrostatic Design Basis
     ASTM D2837
73°F
psi
  
140°F
psi
  
Additional Information
Nominal Value
Unit
Test Method
PENT
day
 ASTM F1473
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Marlex® H525, Marlex H525, Marlex® , Marlex, MarlexH525, H 525, H525, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, CP Chem, PolyethyleneHighDensity, 525H
Features
Features may also be described by the following terms: Good Crack Resistance, Crack Resistant.
Uses
Uses may also be described by the following terms: Piping, Pipe.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): ASTM (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Type IV, 2.0 in/min
30.50 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.