IDES Prospector Already have an account? Login Here

IDES

Badaprene® TPV 70A 1079

Polypropylene + EPDM Rubber

Supplied by Bada AG

The technical datasheet with complete property values for Badaprene® TPV 70A 1079 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Easy flowing Injection moulding grade with low compression set
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Good Flow
  • Low Compression Set
  
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 DIN 53505
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress - Flow (Yield)
psi
 DIN 53505
Tensile Elongation - Flow (Break)
%
 DIN 53505
Tear Strength - Flow
lbf/in
 DIN 53505
Compression Set (158°F, 24.0 hr)
%
 DIN 53505
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A)
 
 DIN 53505
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Badaprene® TPV 70A 1079, Badaprene TPV 70A 1079, Badaprene® , Badaprene, BadapreneTPV70A1079, TPV 70 A 1079, TPV 70A 1079, TPV70, 70A, A1079, TPV70A1079, Polypropylene + EPDM Rubber, Polypropylene EPDM Rubber, Polypropylene : EPDM Rubber, Polypropylene / EPDM Rubber, Polypropylene - EPDM Rubber, Polypropylene _ EPDM Rubber, Polypropylene EPDM Rubber, PP+EPDM, PPEPDM, PP:EPDM, PP/EPDM, PP-EPDM, PP_EPDM, PP EPDM, Polypropylene, PP, Bada Euro, PolypropyleneEPDMRubber, Polypropylene_EPDMRubber, 70TPV
Features
Features may also be described by the following terms: Good Flow, Low Compression Set.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.