IDES Prospector Already have an account? Login Here

IDES

Luvocom® 105-8514

Thermoplastic Elastomer

Supplied by Lehmann & Voss & Co.

The technical datasheet with complete property values for Luvocom® 105-8514 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Central America
  • Europe
  • Latin America
  • North America
  • South America
Features 
  • Good Impact Resistance
  • Thermally Conductive
 
Appearance 
  • Grey
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Molding Shrinkage
%
DIN 16901
Water Absorption (73°F, 24 hr)
%
 
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
ISO 527-2
Tensile Stress (Break)
psi
ISO 527-2
Tensile Strain (Yield)
%
ISO 527-2
Impact
Nominal Value
Unit
Test Method
Charpy Unnotched Impact Strength (73°F)
 
ISO 179/1fU
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore D)
 
ISO 868
Thermal
Nominal Value
Unit
Test Method
Thermal Conductivity 2
Btu·in/hr/ft²/°F
 
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
ohm
IEC 60093
Insulation Resistance
ohm
IEC 60167
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Luvocom® 105-8514, Luvocom 1058514, Luvocom® , Luvocom, Luvocom1058514, 105, 105-8514, 1058514, 105:8514, 105/8514, 105+8514, 105_8514, 105 8514, Thermoplastic Elastomer, TPE, Lehmann & Voss, ThermoplasticElastomer, 8514105
Features
Features may also be described by the following terms: Good Impact Resistance.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
 
Drying Time
hr
 
Rear Temperature
°F
 
Middle Temperature
°F
 
Front Temperature
°F
 
Nozzle Temperature
°F
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Injection Notes
Drying conditions listed are for a dehumidifying dryer.
Notes
1Typical properties: these are not to be construed as specifications.
2Hot-Disk, 60x60x3 mm
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.