IDES Prospector Already have an account? Login Here

IDES

ALFATER XL® A70I 3EF0001

Thermoplastic Vulcanizate

Supplied by ALBIS PLASTIC GmbH

The technical datasheet with complete property values for ALFATER XL® A70I 3EF0001 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  • North America
Additive 
  • UV Stabilizer
Features 
  • Alkali Resistant
  • Good Flexibility
  • Good Flow
  • Good Heat Aging Resistance
  • Good Surface Finish
  • Good Weather Resistance
  • Light Stabilized
  • Ozone Resistant
Uses 
  • Gaskets
  • Seals
  • Thin-walled Parts
Agency Ratings 
RoHS Compliance 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (100% Strain)
psi
ISO 37
Tensile Stress (Break)
psi
ISO 37
Tensile Elongation (Break)
%
ISO 37
Tear Strength
lbf/in
ISO 34-1
Compression Set
    ISO 815
158°F, 24.0 hr
%
 
212°F, 22.0 hr
%
 
257°F, 72.0 hr
%
 
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A)
 
ISO 868
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ALFATER XL® A70I 3EF0001, ALFATER XL A70I 3EF0001, ALFATER XL® , ALFATER XL, ALFATERXLA70I3EF0001, ALFATERXL, A 70 I 3 EF 0001, A70I 3EF0001, A70, 70I, I3, 3EF, EF0001, A70I3EF0001, Thermoplastic Vulcanizate, TPV, Thermoplastic Elastomer, TPE, Albis Euro, ThermoplasticVulcanizate, ThermoplasticElastomer, 70A
Features
Features may also be described by the following terms: Good Flow, Good Surface Finish, Good Flexibility, Flexible, Good Weather Resistance, Weather Resistant, Good Heat Aging Resistance.
Uses
Uses may also be described by the following terms: Thin-walled Parts, Thin Walled Parts, Thin-wall Parts, Thin wall Parts, Thinwall Parts, Gaskets, Gasketing.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): EU (1).
Injection
Nominal Value
Unit
 
Drying Temperature
°F
 
Drying Time
hr
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Injection Rate
 
 
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.