IDES Prospector Already have an account? Login Here

IDES

Braskem PP C154-01Z

Polypropylene Impact Copolymer

Supplied by Braskem America Inc.

The technical datasheet with complete property values for Braskem PP C154-01Z is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Braskem C154-01Z Polypropylene Resin is intended for use in cast film or extrusion processes where good impact strength and stiffness are required.

Main Characteristics:
  • Consistent processability
  • Good balance of stiffness and impact strength
  • Good surface gloss

Complies with:
  • U.S. FDA FCN 843 (with limitation)
  • Consult the regulations for complete details
General  
Material Status 
  • Commercial: Active
Availability 
  • Latin America
  • North America
  
Agency Ratings 
 
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Yield)
%
 ASTM D638
Flexural Modulus - 1% Secant 2
psi
 ASTM D790A
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact 2 (73°F)
ft·lb/in
 ASTM D256A
Gardner Impact 2 (-20°F)
in·lb
 ASTM D5420
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load 2 (66 psi, Unannealed)
°F
 ASTM D648
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Braskem PP C154-01Z, Braskem PP C15401Z, Braskem PP , BraskemPPC15401Z, BraskemPP, C 154, PPC 154 01 Z, PPC 154, PPC154-01Z, PPC15401Z, PPC154:01Z, PPC154/01Z, PPC154+01Z, PPC154_01Z, PPC154 01Z, PPC154, C 154 01 Z, C154-01Z, C15401Z, C154:01Z, C154/01Z, C154+01Z, C154_01Z, C154 01Z, C154, 15401, 01Z, Polypropylene Impact Copolymer, PP Impact Copolymer, Polypropylene, PP, PolypropyleneImpactCopolymer, PPImpactCopolymer, 154C, 154PPC
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), EU (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Testing performed on ASTM D 638 Type I specimen, molded and tested in accordance with ASTM D 4101. Properties will vary with changes in molding conditions and aging time.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.