IDES Prospector Already have an account? Login Here

IDES

ENSOFT SM-141-45A

Styrene Ethylene Butylene Styrene Block Copolymer

Mineral Filler

Supplied by ENPLAST, a Ravago Group Company

The technical datasheet with complete property values for ENSOFT SM-141-45A is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
  • North America
  
Filler / Reinforcement 
  • Mineral Filler
Additive 
  • Heat Stabilizer
  • UV Stabilizer
  
Features 
  • Good Colorability
  • Good Processability
  • Good UV Resistance
  • Heat Stabilized
  • High Elasticity
  • Recyclable Material
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 2781
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress
     ISO 37
100% Strain
psi
  
300% Strain
psi
  
Tensile Stress (Break)
psi
 ISO 37
Tensile Elongation (Break)
%
 ISO 37
Tear Strength - Across Flow
lbf/in
 ISO 34-1
Compression Set
     ASTM D395B
73°F, 72.0 hr
%
  
158°F, 22.0 hr
%
  
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A, 3 sec)
 
 ISO 868
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
  
Service Temperature
      
Maximum Dynamic
°F
  
Maximum Static
°F
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ENSOFT SM-141-45A, ENSOFT SM14145A, ENSOFT , ENSOFTSM14145A, SM, SM 141 45 A, SM-141-45A, SM14145A, SM:141:45A, SM/141/45A, SM+141+45A, SM_141_45A, SM 141 45A, SM141, 14145, 45A, Styrene Ethylene Butylene Styrene Block Copolymer, SEBS, Thermoplastic Elastomer, TPE, Enplast, StyreneEthyleneButyleneStyreneBlockCopolymer, ThermoplasticElastomer, 141SM
Features
Features may also be described by the following terms: Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant, Heat Stabilized, Heat-ageing Stabilized, Heat Ageing Stabilized, Heat-aging Stabilized, Heat Aging Stabilized, Good Colorability, Good Processability, Easy Processing, High Elasticity, Highly Elastic.
Injection
Nominal Value
Unit
 
Hopper Temperature
°F
  
Rear Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Notes
Maximum Allowable Melt Temperature: 250°C
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.