IDES Prospector Already have an account? Login Here

IDES

Halene H B6001L

High Density Polyethylene

Supplied by Haldia Petrochemicals Ltd.

The technical datasheet with complete property values for Halene H B6001L is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
B6001L is a Blow Molding Grade HDPE produced by the Spherilene Technology.

This resin is particularly recommended for upto 20-liter containers for Lubricants and Edible oils.

B6001L combines exceptional processability with high rigidity, excellent mechanical properties and impact resistance.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Good Impact Resistance
  • High Rigidity
  
Uses 
  • Containers
  • Food Containers
  
Processing Method 
  • Blow Molding
Physical
Nominal Value
Unit
Test Method
Density 2
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 3 (Yield, Compression Molded)
psi
 ASTM D638
Tensile Elongation 3 (Break, Compression Molded)
%
 ASTM D638
Flexural Modulus (Compression Molded)
psi
 ASTM D790A
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F, Compression Molded)
ft·lb/in
 ASTM D256A
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Halene H B6001L, Halene H , HaleneHB6001L, HaleneH, HB 6001 L, HB6001L, HB6001, B 6001 L, B6001L, B6001, 6001L, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Haldia Petrochem, PolyethyleneHighDensity, 6001B, 6001HB
Features
Features may also be described by the following terms: High Rigidity, Good Impact Resistance.
Uses
Uses may also be described by the following terms: Food Containers, Food Container.
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Die Temperature
°F
  
Extrusion Notes
Parison Temperature: 185-190°C
Cooling Water for Mold: 20-25°C
Notes
1Typical properties: these are not to be construed as specifications.
223°C
32.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.