IDES Prospector Already have an account? Login Here

IDES

Tecnoflon® FOR 4353

Fluoroelastomer

Supplied by Solvay Specialty Polymers

The technical datasheet with complete property values for Tecnoflon® FOR 4353 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
TECNOFLON® FOR 4353 is a low viscosity cure incorporated fluoroelastomer copolymer. Tecnoflon® FOR 4353 is well suited for applications where excellent compression set and superior mold release are required.

Some of the properties of Tecnoflon® FOR 4353 are:
  • Excellent scorch safety
  • Very Good mold flow
  • Excellent mold release
  • Lack of mold fouling
  • FDA compliant

TECNOFLON® FOR 4353 can be used for injection and transfer moulding of O-rings, gaskets and seals. The product can be mixed using typical fluoroelastomers compounding ingredients and mixing can be accomplished with two-roll mills or internal mixers.
The material can be extruded into hoses or profiles and can be calendered to make sheet stocks or belting. Finished goods can be produced by a variety of rubber processing methods.
TECNOFLON® FOR 4353 can be compounded using recommanded fillers in compliance with FDA regulations (see 21 CFR 177.2600, section V).
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
  • North America
  
Features 
  • Copolymer
  • Food Contact Acceptable
  • Good Flow
  • Good Mold Release
  • Low Compression Set
  • Low Viscosity
Uses 
  • Belts/Belt Repair
  • Blending
  • Gaskets
  • Hose
  • Profiles
  • Seals
  • Sheet
Agency Ratings 
Appearance 
  • Off-White
Forms 
  • Slab
Processing Method 
  • Calendering
  • Compounding
  • Extrusion
  • Injection Molding
  • Resin Transfer Molding
Physical
Nominal Value
Unit
 
Mooney Viscosity 2 (ML 1+10, 250°F)
MU
  
Fluorine Content 2
%
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Tecnoflon® FOR 4353, Tecnoflon FOR 4353, Tecnoflon® , Tecnoflon, TecnoflonFOR4353, FOR 4353, FOR4353, Fluoroelastomer, Fluorelastomer, Fluoropolymer, Solvay Specialty, 4353FOR
Features
Features may also be described by the following terms: Good Mold Release, Easy Release, Good Demolding, Good Flow, Low Viscosity, Low Compression Set.
Uses
Uses may also be described by the following terms: Gaskets, Gasketing, Belts/Belt Repair, Belt Repair.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Raw polymer
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.