IDES Prospector Already have an account? Login Here

IDES

HAIPLEN EP150 C4

Polypropylene Copolymer

Calcium Carbonate Filler, 20%

Supplied by Taro Plast S.p.A.

The technical datasheet with complete property values for HAIPLEN EP150 C4 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Filler / Reinforcement 
  • Calcium Carbonate Filler, 20% Filler by Weight
Features 
  • Copolymer
  • Good Surface Finish
  • High Flow
Appearance 
  • Colors Available
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
ISO 1133
Molding Shrinkage
    Internal Method
Across Flow
%
 
Flow
%
 
Granule Humidity 2
%
Internal Method
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Break)
psi
ISO 527-2/50
Tensile Strain (Break)
%
ISO 527-2/50
Flexural Modulus 3
psi
ISO 178
Impact
Nominal Value
Unit
Test Method
Charpy Notched Impact Strength (73°F)
ft·lb/in²
ISO 179/1eA
Notched Izod Impact (73°F)
ft·lb/in
ASTM D256
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature
     
66 psi, Unannealed
°F
ISO 75-2/B
264 psi, Unannealed
°F
ISO 75-2/A
Vicat Softening Temperature
     
--
°F
ISO 306/A50
--
°F
ISO 306/B50
Electrical
Nominal Value
Unit
Test Method
Comparative Tracking Index (Solution A)
V
IEC 60112
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL (0.126 in)
 
UL 94
Oxygen Index
%
ASTM D2863
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: HAIPLEN EP150 C4, HAIPLEN , HAIPLENEP150C4, EP 150 C 4, EP150 C4, EP150, 150C, C4, EP150C4, Polypropylene Copolymer, PP Copolymer, Polypropylene, PP, Taro Plast, PolypropyleneCopolymer, PPCopolymer, 150EP
Features
Features may also be described by the following terms: Good Surface Finish, High Flow, High Melt, High MFI.
Injection
Nominal Value
Unit
 
Drying Temperature - Pre-heater
°F
 
Drying Time - Pre-heater
hr
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Injection Rate
 
 
Notes
1Typical properties: these are not to be construed as specifications.
2TARO 002
30.039 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.