IDES Prospector Already have an account? Login Here

IDES

RTV-2 P-100

Silicone

Supplied by Silicones, Inc.

The technical datasheet with complete property values for RTV-2 P-100 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
P-100 has been specially formulated for heat resistance and can be used to cast polyurethane solids or foams as well as polyester, epoxies and some low melting point metals. P-100 has a higher specific gravity than P-90, and will exhibit less heat distortion. It has excellent self-leveling characteristics and its mixed viscosity is quite low, enabling the mold maker to cast very intricate models.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Chemical Resistance
  • High Heat Resistance
  • Low Shrinkage
  • Low Viscosity
  
Uses 
  • Molds/Dies/Tools
Appearance 
  • White
Forms 
  • Liquid
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Elastomers
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D412
Tensile Elongation (Break)
%
 ASTM D412
Tear Strength
lbf/in
 ASTM D624
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Max. Continuous Use Temperature
°F
 ASTM D794
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 ASTM D257
Dielectric Strength
V/mil
 ASTM D149
Dielectric Constant (100 Hz)
 
 ASTM D150
Dissipation Factor (100 Hz)
 
 ASTM D150
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
      
Hardener
 
  
Resin
 
  
Pot Life
min
  
Shelf Life
wk
  
Thermoset Mix Viscosity
cP
 ASTM D2393
Demold Time
min
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: RTV-2 P-100, RTV2 P100, RTV-2 , RTV2, RTV:2, RTV/2, RTV+2, RTV_2, RTV 2, RTV2P100, P-100, P100, P:100, P/100, P+100, P_100, P 100, Silicone, Silicones, 100P
Features
Features may also be described by the following terms: Good Chemical Resistance, Chemical Resistant, High Heat Resistance, Low Shrinkage, Low Viscosity.
Uses
Uses may also be described by the following terms: Molds/Dies/Tools, Molds, Dies, tools.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.