IDES Prospector Already have an account? Login Here

IDES

Conap UC-26

Polyurethane

Supplied by Conap, Inc, a Division of Cytec Industries Inc.

The technical datasheet with complete property values for Conap UC-26 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Discontinued
Availability 
  • North America
Features 
  • Good Abrasion Resistance
  • Good Dimensional Stability
  • Good Impact Resistance
  • Good Processability
  • Good Toughness
  • Low Viscosity
  • Scratch Resistant
  • Thixotropic
Uses 
  • Liners
  • Molds/Dies/Tools
  • Prototyping
  • Repairing Material
  
Appearance 
  • Blue
Forms 
  • Liquid
Processing Method 
  • Casting
  • Laminating
  
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Elastomers
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D412
Tensile Elongation (Break)
%
 ASTM D412
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact
ft·lb/in
 ASTM D256
Unnotched Izod Impact
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 ASTM D257
Dielectric Strength (0.0625 in)
V/mil
 ASTM D149
Dielectric Constant (1 kHz)
 
 ASTM D150
Dissipation Factor (1 kHz)
 
 ASTM D150
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
      
Hardener
 
  
Resin
 
  
Pot Life (77°F)
min
  
Shelf Life
wk
  
Demold Time (140°F)
min
  
Post Cure Time (77°F)
hr
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Conap UC-26, Conap UC26, Conap , ConapUC26, UC, UC-26, UC26, UC:26, UC/26, UC+26, UC_26, UC 26, Polyurethane, Unspecified, Polyurethane Unspecified, PUR, Unspecified, PUR Unspecified, Polyurethane, PUR, PolyurethaneUnspecified, PURUnspecified, 26UC
Features
Features may also be described by the following terms: Good Abrasion Resistance, Abrasion Resistant, Good Dimensional Stability, Dimensionally Stable, Good Impact Resistance, Good Processability, Easy Processing, Scratch Resistant, Resists Scratches, Good Toughness, Tough, Low Viscosity.
Uses
Uses may also be described by the following terms: Molds/Dies/Tools, Molds, Dies, tools.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.