IDES Prospector Already have an account? Login Here

IDES

Network Polymers SMMA MS 150

Styrene Methyl Methacrylate Acrylic Copolymer

Supplied by Network Polymers, Inc.

The technical datasheet with complete property values for Network Polymers SMMA MS 150 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Terpolymer
Agency Ratings 
 
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
ASTM D792
Melt Mass-Flow Rate (MFR) 2 (200°C/5.0 kg)
g/10 min
ASTM D1238
Molding Shrinkage - Flow
in/in
ASTM D955
Water Absorption (24 hr)
%
ASTM D570
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
ASTM D638
Tensile Strength 3
psi
ASTM D638
Tensile Elongation 3 (Break)
%
ASTM D638
Flexural Modulus 4
psi
ASTM D790B
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (0.125 in)
ft·lb/in
ASTM D256A
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (66 psi, Unannealed)
°F
ASTM D648
Vicat Softening Temperature
°F
ASTM D1525
Optical
Nominal Value
Unit
Test Method
Transmittance
%
ASTM D1003
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Network Polymers SMMA MS 150, Network Polymers SMMA , NetworkPolymersSMMAMS150, NetworkPolymersSMMA, SMMAMS 150, SMMA, SMMAMS150, MS 150, MS150, Acrylic, Acrylic, Styrene Methyl Methacrylate Copolymer, Acrylic Styrene Methyl Methacrylate Copolymer, Acrylic (SMMA), Acrylic SMMA, Network Poly, AcrylicStyreneMethylMethacrylateCopolymer, AcrylicSMMA, 150MS, 150SMMAMS
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (2).
Notes
1Typical properties: these are not to be construed as specifications.
2Procedure A
32.0 in/min
4Method I (3 point load), 0.050 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.