IDES Prospector Already have an account? Login Here

IDES

ULTEM* 1110 Resin

Polyether Imide

Supplied by SABIC Innovative Plastics

The technical datasheet with complete property values for ULTEM* 1110 Resin is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Enhanced flow Polyetherimide (Tg 217C). ECO Conforming.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • ECO Compliant
  • Good Flow
  
Agency Ratings 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (337°C/6.6 kg)
g/10 min
 ASTM D1238
Molding Shrinkage - Flow (0.126 in)
in/in
 Internal Method
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus 2
psi
 ASTM D638
Tensile Strength 3 (Yield)
psi
 ASTM D638
Tensile Elongation 3 (Break)
%
 ASTM D638
Flexural Modulus 4 (3.94 in Span)
psi
 ASTM D790
Flexural Strength 4 (Yield, 3.94 in Span)
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Reverse Notch Izod Impact (0.126 in)
ft·lb/in
 ASTM D256
Gardner Impact (73°F)
in·lb
 ASTM D3029
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed, 0.252 in)
°F
 ASTM D648
Related Terminology
This supplier and product may also be known by these terms: GE Plastics, LNP Engineering Plastics, GE Polymerland

Product names can be difficult to match. You may have searched any one of these terms to find this product: ULTEM* 1110 Resin, ULTEM 1110 Resin, ULTEM* , ULTEM, ULTEM1110Resin, 1110 Resin, 1110Resin, Polyether Imide, PEI, SABIC IP, PolyetherImide, Resin1110
Features
Features may also be described by the following terms: Good Flow.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): EU (1).
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Drying Time, Maximum
hr
  
Suggested Max Moisture
%
  
Suggested Shot Size
%
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Back Pressure
psi
  
Screw Speed
rpm
  
Vent Depth
in
  
Notes
1Typical properties: these are not to be construed as specifications.
20.20 in/min
3Type I, 0.20 in/min
40.10 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.