IDES Prospector Already have an account? Login Here

IDES

Vitax V6820

Acrylonitrile Styrene Acrylate

Supplied by Hitachi Chemical Co., Ltd.

The technical datasheet with complete property values for Vitax V6820 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Chemical Resistance
  • Good Impact Resistance
  • Good Weather Resistance
  • High Heat Resistance
  
Uses 
  • Automotive Exterior Parts
  • Automotive Interior Parts
  • Safety Helmets
Forms 
  • Pellets
Processing Method 
  • Extrusion
  • Injection Molding
  • Vacuum Forming
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (200°C/5.0 kg)
g/10 min
 ASTM D1238
Molding Shrinkage - Flow
in/in
 ASTM D955
Water Absorption (24 hr)
%
 ASTM D570
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength (Yield)
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F, 0.125 in)
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (R-Scale)
 
 ASTM D785
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed)
°F
 ASTM D648
CLTE - Flow
in/in/°F
 ASTM D696
Thermal Conductivity
Btu·in/hr/ft²/°F
 ASTM C177
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 ASTM D257
Dielectric Strength
V/mil
 ASTM D149
Dielectric Constant
     ASTM D150
60 Hz
 
  
1 MHz
 
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Vitax V6820, Vitax , VitaxV6820, V 6820, V6820, Acrylonitrile Styrene Acrylate, ASA, Hitachi, AcrylonitrileStyreneAcrylate, 6820V
Features
Features may also be described by the following terms: Good Chemical Resistance, Chemical Resistant, High Heat Resistance, Good Impact Resistance, Good Weather Resistance, Weather Resistant.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Mold Temperature
°F
  
Injection Pressure
psi
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.