IDES Prospector Already have an account? Login Here

IDES

PermaStat® 200

Polyamide 66

Supplied by RTP Company

The technical datasheet with complete property values for PermaStat® 200 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
  • Latin America
  • North America
  • South America
Additive 
  • Antistatic
Features 
  • Antistatic
  • ESD Protection
  
RoHS Compliance 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow (0.125 in)
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
 ASTM D638
Tensile Strength
psi
 ASTM D638
Tensile Elongation (Yield)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (0.125 in)
ft·lb/in
 ASTM D256
Unnotched Izod Impact (0.125 in)
ft·lb/in
 ASTM D4812
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
      
-- 2
ohms
 ASTM D257
--
ohms
 ESD STM11.11
Volume Resistivity
ohm·cm
 ASTM D257
Static Decay 3
 
 FTMS 101C 4046.1
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: PermaStat® 200, PermaStat 200, PermaStat® , PermaStat, PermaStat200, 200, Polyamide 66, Nylon 66, Polyamide, Nylon, pa66, RTP, Polyamide66, Nylon66
Generic Name
Generic Name may also be described by the following terms: PA66.
Features
Features may also be described by the following terms: Electrostatic Discharge Protection, ESD Protection.
Injection
Nominal Value
Unit
 
Drying Temperature - Desiccant Dryer
°F
  
Drying Time - Desiccant Dryer
hr
  
Dew Point - Desiccant Dryer
°F
  
Suggested Max Moisture
%
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Pressure
psi
  
Injection Notes
Desiccant Type Dryer Required.
Do not exceed 520 °F (270 °C) melt temperature.
Notes
1Typical properties: these are not to be construed as specifications.
2ESD STM11.11
3MIL-PRF-81705D, 5kV to 50 V, 12% Rh
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.