IDES Prospector Already have an account? Login Here

IDES

Favorite REG101

Polyethylene

Supplied by Favorite Plastics

The technical datasheet with complete property values for Favorite REG101 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • Low Slip
Features 
  • High Clarity
  • High Gloss
  • High Strength
  • Low Slip
  
Uses 
  • Laminates
Agency Ratings 
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Coefficient of Friction (vs. Itself - Static)
 
 ASTM D1894
Films
Nominal Value
Unit
Test Method
Film Thickness - Tested
mil
  
Tensile Strength - MD
     ASTM D882
Yield
psi
  
Break
psi
  
Tensile Elongation - MD (Break)
%
 ASTM D882
Dart Drop Impact
g
 ASTM D1709
Optical
Nominal Value
Unit
Test Method
Gloss (45°)
 
 ASTM D2457
Haze
%
 ASTM D1003
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Favorite REG101, Favorite , FavoriteREG101, REG 101, REG101, Polyethylene, Unspecified, Polyethylene Unspecified, PE, Unspecified, PE Unspecified, Polyethylene, PE, PolyethyleneUnspecified, PEUnspecified, 101REG
Features
Features may also be described by the following terms: Low Slip, High Clarity, High Gloss, High Strength.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.