IDES Prospector Already have an account? Login Here

IDES

Favorite LL565

Linear Low Density Polyethylene + EVA

Supplied by Favorite Plastics

The technical datasheet with complete property values for Favorite LL565 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Uses 
  • Bags
Forms 
  • Film
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Coefficient of Friction (vs. Itself - Static)
 
 ASTM D1894
Films
Nominal Value
Unit
Test Method
Film Thickness - Tested
mil
  
Tensile Strength
     ASTM D882
MD: Break
psi
  
TD: Break
psi
  
Tensile Elongation
     ASTM D882
MD: Break
%
  
TD: Break
%
  
Dart Drop Impact
g
 ASTM D1709
Optical
Nominal Value
Unit
Test Method
Gloss (45°)
 
 ASTM D2457
Haze
%
 ASTM D1003
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Favorite LL565, Favorite , FavoriteLL565, LL 565, LL565, Polyethylene, Linear Low Density + EVA, Polyethylene Linear Low Density EVA, Polyethylene, Linear Low Density : EVA, Polyethylene, Linear Low Density / EVA, Polyethylene, Linear Low Density - EVA, Polyethylene, Linear Low Density _ EVA, Polyethylene, Linear Low Density EVA, LLDPE+EVA, LLDPEEVA, LLDPE:EVA, LLDPE/EVA, LLDPE-EVA, LLDPE_EVA, LLDPE EVA, Polyethylene, PE, PolyethyleneLinearLowDensityEVA, Polyethylene Linear Low Density _ EVA, PolyethyleneLinearLowDensity_EVA, 565LL
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.