IDES Prospector Already have an account? Login Here

IDES

VECTOR® 4411-D

Styrene Isoprene Styrene Block Copolymer

Supplied by Dexco Polymers LP

The technical datasheet with complete property values for VECTOR® 4411-D is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Discontinued
Availability 
  • North America
Features 
  • Copolymer
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Blow Molding
  • Extrusion
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
ASTM D792
Melt Mass-Flow Rate (MFR) (200°C/5.0 kg)
g/10 min
ASTM D1238
Molding Shrinkage - Flow
in/in
ASTM D955
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (300% Strain)
psi
ASTM D412
Tensile Strength (Yield)
psi
ASTM D412
Tensile Elongation (Break)
%
ASTM D412
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
ASTM D2240
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: VECTOR® 4411-D, VECTOR 4411D, VECTOR® , VECTOR, VECTOR4411D, 4411, 4411-D, 4411D, 4411:D, 4411/D, 4411+D, 4411_D, 4411 D, Styrene Isoprene Styrene Block Copolymer, SIS, Thermoplastic Elastomer, TPE, Dexco, StyreneIsopreneStyreneBlockCopolymer, ThermoplasticElastomer, D4411
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Injection Pressure
psi
 
Injection Rate
 
 
Back Pressure
psi
 
Screw Speed
rpm
 
Clamp Tonnage
tons/in²
 
Screw Compression Ratio
 
 
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.