IDES Prospector Already have an account? Login Here

IDES

Kemcor LD 9151

Low Density Polyethylene

Supplied by Qenos Pty Ltd

The technical datasheet with complete property values for Kemcor LD 9151 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
This resin is manufactured to conform to the requirements for unrestricted food contact of AS 2070 Part 1 (1992).
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Fast Molding Cycle
  • Good Flexibility
  • Good Processability
  • High Flow
  • Low Warpage
Uses 
  • Closures
  • Containers
  • Thin-walled Parts
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
 ASTM D638
Tensile Strength
     ASTM D638
Yield
psi
  
Break
psi
  
Tensile Elongation (Break)
%
 ASTM D638
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Kemcor LD 9151, Kemcor , KemcorLD9151, LD 9151, LD9151, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, Qenos, PolyethyleneLowDensity, 9151LD
Features
Features may also be described by the following terms: High Flow, High Melt, High MFI, Good Flexibility, Flexible, Good Processability, Easy Processing, Fast Cycle, Rapid Cycle, Productivity, Fast Molding Cycle, Low Warpage, Low Warp.
Uses
Uses may also be described by the following terms: Thin-walled Parts, Thin Walled Parts, Thin-wall Parts, Thin wall Parts, Thinwall Parts.
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.