IDES Prospector Already have an account? Login Here

IDES

SCLAIR® 2807

High Density Polyethylene

Supplied by NOVA Chemicals

The technical datasheet with complete property values for SCLAIR® 2807 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • Antioxidant
Features 
  • Antioxidant
  • Food Contact Acceptable
  • Good Colorability
  • Good Organoleptic Properties
  • Good Processability
  • Good Stiffness
  • Low Temperature Impact Resistance
Uses 
  • Caps
  • Closures
  • Industrial Applications
  • Pails
  
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Environmental Stress-Cracking Resistance (100% Igepal, F50)
hr
 ASTM D1693A
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: SCLAIR® 2807, SCLAIR 2807, SCLAIR® , SCLAIR, SCLAIR2807, 2807, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Nova Chemicals, PolyethyleneHighDensity
Features
Features may also be described by the following terms: Good Stiffness, Good Processability, Easy Processing, Good Colorability, Low Temperatuer Impact Resistance, Low Temp Impact Resistance, Good Organoleptic Properties.
Uses
Uses may also be described by the following terms: Closure Caps, Caps, Cap.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.