|
Specific Gravity
|
|
|
ASTM D792 |
|
Apparent Density
|
|
g/cm³
|
|
|
Melt Mass-Flow Rate (MFR) (200°C/5.0 kg)
|
|
g/10 min
|
ASTM D1238 |
|
Molding Shrinkage - Flow (73°F, Injection Molded)
|
|
in/in
|
ASTM D955 |
|
Tensile Modulus (73°F, Injection Molded)
|
|
psi
|
ASTM D638 |
|
Tensile Strength (Yield, 73°F, Injection Molded)
|
|
psi
|
ASTM D638 |
|
Tensile Elongation (Break, 73°F, Injection Molded)
|
|
%
|
ASTM D638 |
|
Flexural Modulus (73°F, Injection Molded)
|
|
psi
|
ASTM D790 |
|
Flexural Strength (73°F, Injection Molded)
|
|
psi
|
ASTM D790 |
|
Notched Izod Impact 2 (73°F, 0.125 in, Injection Molded)
|
|
ft·lb/in
|
ASTM D256 |
|
Rockwell Hardness (L-Scale, 73°F, Injection Molded)
|
|
|
ASTM D785 |
|
Deflection Temperature Under Load (264 psi, Annealed, Injection Molded)
|
|
°F
|
ASTM D648 |
|
Vicat Softening Temperature
|
|
°F
|
ASTM D1525 |
|
CLTE - Flow
|
|
in/in/°F
|
ASTM D696 |
|
Dielectric Strength (73°F, 0.125 in)
|
|
V/mil
|
ASTM D149 |
|
Dielectric Constant (73°F, 1 MHz)
|
|
|
ASTM D150 |
|
Gardner Gloss (60°, Injection Molded)
|
|
|
ASTM D523 |
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: Impact PS 5310, Impact PS , ImpactPS5310, ImpactPS, PS 5310, PS5310, PS, 5310, Polystyrene, High Impact, Polystyrene High Impact, PS (HIPS), PS HIPS, Polystyrene, Styrolution, PolystyreneHighImpact, PSHIPS, 5310PS
|
|
Features may also be described by the following terms: High Environmental Stress Cracking Resistance, High ESCR, Stress Cracking Resistant, Good Impact Resistance, Good Toughness, Tough, Excellent Printability, Printable.
|
|
Uses may also be described by the following terms: Food Packaging, Decorative Displays.
|
|
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
|