IDES Prospector Already have an account? Login Here

IDES

Kaneka MUH LG5012

Acrylonitrile Butadiene Styrene

Supplied by Kaneka Corporation

The technical datasheet with complete property values for Kaneka MUH LG5012 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Impact Resistance
  • Good Moldability
  • High Heat Resistance
  • Low Gloss
  
Uses 
  • Automotive Applications
  • Electrical/Electronic Applications
  
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact
     ASTM D256
-22°F, 0.126 in
ft·lb/in
  
-22°F, 0.252 in
ft·lb/in
  
73°F, 0.126 in
ft·lb/in
  
73°F, 0.252 in
ft·lb/in
  
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (R-Scale)
 
 ASTM D785
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load
     ASTM D648
66 psi, Unannealed
°F
  
264 psi, Unannealed
°F
  
CLTE - Flow
in/in/°F
 ASTM D696
Optical
Nominal Value
Unit
Test Method
Gardner Gloss (60°)
 
 ASTM D523
Additional Information
Coefficient of Linear Thermal Expansion, Kaneka Method, flow: 7-9 E-5 cm/cm/°C
Mold Shrinkage, Kaneka Method, flow, 73°F: 5-8 mil/in
Spiral Flow, Kaneka Method, 482°F: 26 in
Reflective Rate, Kaneka Method, 60°, 73°F: 22 %
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Kaneka MUH LG5012, Kaneka MUH , KanekaMUHLG5012, KanekaMUH, MUHLG 5012, MUHLG5012, MUH, LG 5012, LG5012, Acrylonitrile Butadiene Styrene, ABS, Kaneka, AcrylonitrileButadieneStyrene, 5012LG, 5012MUHLG
Features
Features may also be described by the following terms: Low Gloss, Good Impact Resistance, High Heat Resistance, Good Moldability.
Uses
Uses may also be described by the following terms: Automotive Applications, Automotive Sector, Electrical Applications, Electronic Applications, Electrical/Electronic Applications, Electrical Sector.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.