IDES Prospector Already have an account? Login Here

IDES

Kaneka MUH M3100

Acrylonitrile Butadiene Styrene

Supplied by Kaneka Corporation

The technical datasheet with complete property values for Kaneka MUH M3100 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Chemical Resistance
  • Good Impact Resistance
  • Good Moldability
  • High Heat Resistance
  
Uses 
  • Automotive Applications
  • Electrical/Electronic Applications
  
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (0.252 in)
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (R-Scale)
 
 ASTM D785
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed)
°F
 ASTM D648
Additional Information
Spiral Flow, Kaneka Method, 482°F, 3 mm: 18.8 in
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Kaneka MUH M3100, Kaneka MUH , KanekaMUHM3100, KanekaMUH, MUHM 3100, MUHM3100, MUH, M 3100, M3100, Acrylonitrile Butadiene Styrene, ABS, Kaneka, AcrylonitrileButadieneStyrene, 3100M, 3100MUHM
Features
Features may also be described by the following terms: Good Impact Resistance, High Heat Resistance, Good Moldability, Good Chemical Resistance, Chemical Resistant.
Uses
Uses may also be described by the following terms: Automotive Applications, Automotive Sector, Electrical Applications, Electronic Applications, Electrical/Electronic Applications, Electrical Sector.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.