IDES Prospector Already have an account? Login Here

IDES

WPP TPO TPO-180

Compounded Polypropylene

Supplied by Washington Penn Plastic Co. Inc.

The technical datasheet with complete property values for WPP TPO TPO-180 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
This TPO compound has been tailored specifically to meet the requirements of each of the major automobile producers. Features include good scuff, nick and wear resistance and also very good ductility and practical toughness. This compound also features an excellent balance of impact strength and rigidity. This material is suitable for various applications.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Ductile
  • Good Impact Resistance
  • Good Melt Strength
  • Good Toughness
  • Good Wear Resistance
  • High Rigidity
  • Scratch Resistant
Appearance 
  • Colors Available
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR)
g/10 min
 ASTM D1238
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Flexural Modulus - Tangent 3
psi
 ASTM D790
Flexural Strength 3
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (70°F)
ft·lb/in
 ASTM D256
Gardner Impact (70°F)
in·lb
 ASTM D3029
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: WPP TPO TPO-180, WPP TPO TPO180, WPP TPO , WPPTPOTPO180, WPPTPO, TPO, TPOTPO-180, TPOTPO180, TPOTPO:180, TPOTPO/180, TPOTPO+180, TPOTPO_180, TPOTPO 180, TPOTPO, TPO-180, TPO180, TPO:180, TPO/180, TPO+180, TPO_180, TPO 180, Polypropylene, Compounded, Polypropylene Compounded, Polypropylene, PP, Washington Penn, PolypropyleneCompounded, 180TPO, 180TPOTPO
Features
Features may also be described by the following terms: Scratch Resistant, Resists Scratches, Good Wear Resistance, Wear Resistant, Good Toughness, Tough, Good Impact Resistance, High Rigidity, Good Melt Strength.
Injection
Nominal Value
Unit
 
Suggested Max Regrind
%
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Rate
 
  
Clamp Tonnage
tons/in²
  
Injection Notes
Moderate to high injection pressure is recommended.
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
30.050 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.