IDES Prospector Already have an account? Login Here

IDES

Daplen™ BEC 5012 gray 7037

High Density Polyethylene

Supplied by Borealis AG

The technical datasheet with complete property values for Daplen™ BEC 5012 gray 7037 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Forms 
  • Pellets
Processing Method 
  • Blow Molding
Multi-Point Data 
  • Shear Modulus vs. Temperature (ISO 11403-1)
Physical
Nominal Value
Unit
Test Method
Density
lb/in³
 ISO 1183 2
Melt volume-flow rate (230°C/2.16 kg)
in³/10min
 ISO 1133 2
Mechanical
Nominal Value
Unit
Test Method
Tensile modulus
psi
 ISO 527-2 2
Tensile Stress (Yield)
psi
 ISO 527-2 2
Tensile Strain (Yield)
%
 ISO 527-2 2
Nominal strain at break
%
 ISO 527-2 2
Impact
Nominal Value
Unit
Test Method
Charpy notched impact strength (73°F)
ft·lb/in²
 ISO 179/1eA 2
Charpy impact strength (73°F)
 
 ISO 179/1eU 2
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi)
°F
 ISO 75-2 2
Vicat Softening Temperature (50°C/h, B (50N))
°F
 ISO 306 2
Melting Temperature 3
°F
 ISO 11357-3 2
Electrical
Nominal Value
Unit
Test Method
Volume resistivity
ohm·in
 IEC 60093 2
Relative Permittivity (1 MHz)
 
 IEC 60250 2
Dissipation Factor (1 MHz)
 
 IEC 60250 2
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Daplen™ BEC 5012 gray 7037, Daplen BEC 5012 gray 7037, Daplen™ , Daplen, DaplenBEC5012gray7037, BEC 5012 gray 7037, BEC5012, 5012gray, gray7037, BEC5012gray7037, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Borealis, PolyethyleneHighDensity, 5012BEC
Notes
1Typical properties: these are not to be construed as specifications.
2Tested in accordance with ISO 10350. 23°C/50%r.h. unless otherwise noted.
318 °F/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.