IDES Prospector Already have an account? Login Here

IDES

Vikalloy IM90

Acrylic (PMMA) + PVC

Supplied by Viking Polymers, LLC

The technical datasheet with complete property values for Vikalloy IM90 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  • North America
Features 
  • Cleanable
  • Flame Retardant
  • Good Chemical Resistance
  • Solvent Resistant
  
Appearance 
  • Colors Available
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow (0.125 in)
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (0.125 in)
psi
 ASTM D638
Tensile Elongation (Break, 0.125 in)
%
 ASTM D638
Flexural Modulus (0.125 in)
psi
 ASTM D790
Flexural Strength (0.125 in)
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F, 0.125 in)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Annealed, 0.125 in)
°F
 ASTM D648
Additional Information
Specific Gravity, ASTM D792: 1.46 - 1.49
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Vikalloy IM90, Vikalloy , VikalloyIM90, IM 90, IM90, Acrylic + PVC, Acrylic PVC, Acrylic (PMMA) + PVC, Acrylic PMMA PVC, Acrylic (PMMA) : PVC, Acrylic : PVC, Acrylic (PMMA) / PVC, Acrylic / PVC, Acrylic (PMMA) - PVC, Acrylic - PVC, Acrylic (PMMA) _ PVC, Acrylic _ PVC, Acrylic _ PVC, Acrylic (PMMA) PVC, Acrylic PVC, PMMA+PVC, PMMAPVC, PMMA:PVC, PMMA/PVC, PMMA-PVC, PMMA_PVC, PMMA PVC, Acrylic, AcrylicPMMAPVC, Acrylic PMMA _ PVC, AcrylicPMMA_PVC, 90IM
Features
Features may also be described by the following terms: Good Chemical Resistance, Chemical Resistant.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Middle Temperature
°F
  
Front Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Back Pressure
psi
  
Injection Notes
Drying is typically not necessary, however if the material is old or has been stored in moist conditions follow drying parameters listed.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.