IDES Prospector Already have an account? Login Here

IDES

Clariant Nylon 6 PA213N40

Polyamide 6

Glass\Mineral, 40%

Supplied by Clariant Performance Plastics

The technical datasheet with complete property values for Clariant Nylon 6 PA213N40 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Filler / Reinforcement 
  • Glass\Mineral, 40% Filler by Weight
Uses 
  • Automotive Applications
Automotive Specifications 
 
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D638
Tensile Elongation (Yield)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength (Yield)
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load
     ASTM D648
66 psi, Unannealed, 0.250 in
°F
  
264 psi, Unannealed, 0.250 in
°F
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Clariant Nylon 6 PA213N40, Clariant Nylon 6 , ClariantNylon6PA213N40, ClariantNylon6, 6 PA 213 N 40, 6PA213N40, 6PA, PA 213 N 40, PA213N40, PA213, 213N, N40, Polyamide 6, Nylon 6, Polyamide, Nylon, Clariant Perf, Polyamide6, Nylon6, 213PA, PA6
Generic Name
Generic Name may also be described by the following terms: PA6.
Uses
Uses may also be described by the following terms: Automotive Applications, Automotive Sector.
Automotive Specifications
This plastic material has approval for 2 automotive specifications from the following agencies (the number in parentheses shows the number of specifications for that agency): GM (2).
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Suggested Max Moisture
%
  
Suggested Shot Size
%
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Pressure
psi
  
Back Pressure
psi
  
Screw Speed
rpm
  
Injection Notes
This material should be dried in a dessicant dryer.
Injection Pressure, Initial: 1200 to 2000 psi
Injection Pressure, Secondary: 60% of Initial
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.