IDES Prospector Already have an account? Login Here

IDES

Formolene® 4101P

Polypropylene Homopolymer

Supplied by Formosa Plastics Corporation, U.S.A.

The technical datasheet with complete property values for Formolene® 4101P is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Food Contact Acceptable
  • Gas-fading Resistant
  • Good Processability
  • Good Stability
  • Good UV Resistance
  • Homopolymer
  • Low Viscosity
Uses 
  • Fibers
  • Filaments
  
Agency Ratings 
 
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (230°C/3.8 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Yield)
%
 ASTM D638
Flexural Modulus - 1% Secant 3
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (R-Scale)
 
 ASTM D785
Additional Information
Charpy Impact Strength, ASTM D256, Notched, 73°F: 0.8 ft-lb/in
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Formolene® 4101P, Formolene 4101P, Formolene® , Formolene, Formolene4101P, 4101 P, 4101P, Polypropylene Homopolymer, PP Homopolymer, Polypropylene, PP, Formosa Plastics, PolypropyleneHomopolymer, PPHomopolymer, P4101
Features
Features may also be described by the following terms: Good Processability, Easy Processing, Good Stability, Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant, Gas-fading Resistant, Gas Fading Resistant, Low Viscosity.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), EC (1).
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
30.051 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.