IDES Prospector Already have an account? Login Here

IDES

Nucrel® 0910HS

Ethylene Methacrylic Acid

Supplied by DuPont Packaging & Industrial Polymers

The technical datasheet with complete property values for Nucrel® 0910HS is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Nucrel® 0910HS is a copolymer of ethylene and methacrylic acid made with nominally 9 wt% methacrylic acid. It is available for use in conventional extrusion coating, coextrusion coating and extrusion laminating equipment.
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
  • Latin America
  • North America
  • South America
Features 
  • Copolymer
  • Good Drawdown
  • Good Stability
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Extrusion Coating
Physical
Nominal Value
Unit
Test Method
Specific Gravity
      
--
 
 ASTM D792
--
g/cm³
 ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238, ISO 1133
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525, ISO 306
Melting Temperature
°F
 DSC, ISO 3146
Additional Information
Methacrylic Acid Content: 8.7%
Freezing Point (DSC), ASTM D3418: 84°C
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Nucrel® 0910HS, Nucrel 0910HS, Nucrel® , Nucrel, Nucrel0910HS, 0910 HS, 0910HS, Ethylene Methacrylic Acid, EMAA, Thermoplastic Elastomer, TPE, DuPont P&IP, EthyleneMethacrylicAcid, ThermoplasticElastomer, HS0910
Features
Features may also be described by the following terms: Good Drawdown, Good draw down, Good Stability.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Adapter Temperature
°F
  
Melt Temperature
°F
  
Die Temperature
°F
  
Extrusion Notes
Processing conditions shown are for extrusion coating/lamination.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.