Pebax® 7233 SA 01 Arkema Polyether Block Amide

General

Material Status

Availability

Features

Forms

Processing Method

Physical	Nominal Value	Unit	Test Method
Specific Gravity			ASTM D792
Melt Mass-Flow Rate (MFR) (235°C/1.0 kg)		g/10 min	ASTM D1238
Molding Shrinkage			ASTM D955
Flow		in/in
Across Flow		in/in
Mechanical	Nominal Value	Unit	Test Method
Tensile Strength (Ultimate)		psi	ASTM D638
Tensile Elongation (Break)		%	ASTM D638
Flexural Modulus		psi	ASTM D790
Taber Abrasion Resistance (1000 Cycles, 1000 g, H-18 Wheel)		mg	ASTM D1044
Elastomers	Nominal Value	Unit	Test Method
Tear Strength²		lbf/in	ASTM D624
Impact	Nominal Value	Unit	Test Method
Notched Izod Impact			ASTM D256
-40°F		ft·lb/in
68°F		ft·lb/in
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore D)			ASTM D2240
Thermal	Nominal Value	Unit	Test Method
Deflection Temperature Under Load (66 psi, Unannealed)		°F	ASTM D648
Vicat Softening Temperature		°F	ASTM D1525
Melting Temperature		°F
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Pebax® 7233 SA 01, Pebax 7233 SA 01, Pebax® , Pebax, Pebax7233SA01, 7233 SA 01, 7233SA, SA01, 7233SA01, Polyether Block Amide, PEBA-Ether, PEBAEther, PEBA:Ether, PEBA/Ether, PEBA+Ether, PEBA_Ether, PEBA Ether, Thermoplastic Elastomer, TPE, Arkema, PolyetherBlockAmide, ThermoplasticElastomer, SA7233
Features
Features may also be described by the following terms: Good Chemical Resistance, Chemical Resistant, Good Colorability, Good Impact Resistance, Low Temperatuer Impact Resistance, Low Temp Impact Resistance.

Notes

¹Typical properties: these are not to be construed as specifications.

²Die C

Pebax® 7233 SA 01