IDES Prospector Already have an account? Login Here

IDES

Quattor PP KM6100

Polypropylene Homopolymer

Supplied by Quattor Petroquímica

The technical datasheet with complete property values for Quattor PP KM6100 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
KM6100 is a low fluidity homopolymer with good balance of stiffness and impact.

PROCESS AND TYPICAL APPLICATIONS: Injection Molding of thick parts, caps, closures, etc.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
  • South America
  
Features 
  • Food Contact Acceptable
  • Good Impact Resistance
  • Good Stiffness
  • Homopolymer
  • Low Flow
Uses 
  • Caps
  • Closures
  • Thick-walled Parts
Agency Ratings 
 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Yield)
%
 ASTM D638
Flexural Modulus 3
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D, 1 sec)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (66 psi, Unannealed)
°F
 ASTM D648
Vicat Softening Temperature
°F
 ASTM D1525 4
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Quattor PP KM6100, Quattor PP , QuattorPPKM6100, QuattorPP, PPKM 6100, PPKM6100, PP, KM 6100, KM6100, Polypropylene Homopolymer, PP Homopolymer, Polypropylene, Quattor Petroquimica, PolypropyleneHomopolymer, PPHomopolymer, 6100KM, 6100PPKM
Features
Features may also be described by the following terms: Good Stiffness, Good Impact Resistance, Low Flow, Low Melt, Low MFI.
Uses
Uses may also be described by the following terms: Thick-walled Parts, Thick Walled Parts, Thick-wall Parts, Thick Wall Parts, Thickwall Parts, Closure Caps, Caps, Cap.
Agency Ratings
This plastic material has 4 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): ANSI (1), ANVISA (1), FDA (2).
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
30.051 in/min
4Rate A (50°C/h), Loading 1 (10 N)
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.