IDES Prospector Already have an account? Login Here

IDES

Alathon® H6030

High Density Polyethylene

Supplied by LyondellBasell Industries

The technical datasheet with complete property values for Alathon® H6030 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
ALATHON H 6030 is a homopolymer that provides enhanced processability, excellent stiffness and short molding cycles. Typical applications include thin wall and deep-draw.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  • North America
  • South America
  
Features 
  • Fast Molding Cycle
  • Food Contact Acceptable
  • Good Processability
  • Good Stiffness
  • Homopolymer
Uses 
  • Thin-walled Parts
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Break)
psi
 ASTM D638
Flexural Modulus 2
     ASTM D790
1% Secant
psi
  
2% Secant
psi
  
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (66 psi, Unannealed)
°F
 ASTM D648
Brittleness Temperature
°F
 ASTM D746
Vicat Softening Temperature
°F
 ASTM D1525
Additional Information
Spiral Flow, Equistar Test Method, 0.625 in insert, 1000 psi injection pressure, 440°F melt temperature: 16 in
Related Terminology
This supplier and product may also be known by these terms: LyondellBasell Industries, Lyondell, Basell, Bassell, Basell Polyolefins, Bassel

Product names can be difficult to match. You may have searched any one of these terms to find this product: Alathon® H6030, Alathon H6030, Alathon® , Alathon, AlathonH6030, H 6030, H6030, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, LyondellBasell, PolyethyleneHighDensity, 6030H
Features
Features may also be described by the following terms: Good Stiffness, Good Processability, Easy Processing, Fast Cycle, Rapid Cycle, Productivity, Fast Molding Cycle.
Uses
Uses may also be described by the following terms: Thin-walled Parts, Thin Walled Parts, Thin-wall Parts, Thin wall Parts, Thinwall Parts.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
20.50 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.