IDES Prospector Already have an account? Login Here

IDES

REXtac® APAO RT 1310

Polyalphaolefin

Supplied by Huntsman Corporation

The technical datasheet with complete property values for REXtac® APAO RT 1310 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Copolymer
Uses 
  • Laminates
Agency Ratings 
RoHS Compliance 
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Fill Analysis
Nominal Value
Unit
Test Method
Melt Density (375°F)
g/cm³
  
Additional Information
Melt Viscosity, ASTM D3236, 375°F: 1000 cps

Needle Penetration, ASTM D1321, 25°C: 2.5 mm

Softening Point by Ring and Ball, ASTM E28: 280°F

Flashpoint, COC, ASTM D93: >450°F

Open Time, Kraft/Kraft, 25°C, Huntsman Method: 20 seconds
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: REXtac® APAO RT 1310, REXtac APAO RT 1310, REXtac® APAO , REXtac APAO, REXtacAPAORT1310, REXtacAPAO, APAORT 1310, APAO, APAORT1310, RT 1310, RT1310, Polyalphaolefin, PAO, Polyolefin, Huntsman, 1310RT, 1310APAORT
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.